Setup guide

26 Chapter 2 Installing or Replacing Components
Important: Save the blank drive module. Always keep a blank drive module in any
unused drive bay to maintain proper airow through the Xserve.
Remove the blank
drive module from the bay.
If there is a drive module already in the bay:
a Make sure the drive currently in the bay is not being used by any application or
being shared by the Xserve.
b Press the handle on the drive module so the handle pops out.
c Wait for the green, upper disk status light to go o. Then grasp the handle and
pull the drive module out of the bay. If the light doesn’t go out after 20 seconds,
an application probably has a le open on the drive.