System information

12 Chapter 1 Configuring an Xserve RAID System
Network Address
You use the Network pane of the Settings window to set the IP address for each RAID
controller in the system.
•
If you have one or two static IP addresses, choose Manually from the Configure pop-
up menu and type the address, subnet mask, and router information.
•
If you don’t have a static IP address, choose Using DHCP from the Configure pop-up
menu. (DHCP is the default setting for the system.)
For specific information about the IP address and other network details for your system,
check with the network administrator at your location.