Specifications

Installing the card
IMPORTANT Some cards may need to be installed by an Apple-authorized
service provider. Check the information that came with the card.
Follow these steps to install an expansion card.
1 Shut down the server, disconnect any attached cables (including the power cord), and
press the power switch once to discharge static electricity.
2 Remove the lid from the server.
Pull up on the two latches at the rear corners of the case.
Tilt the cover and slide it toward the front panel. Then lift the cover off.
Tilt the back of the cover toward the
front of the computer and lift it off.
Lift up on the latches.
Installing an expansion card 27