User guide

Fully ChargedChargingNot Charging

OffRedOffNormal

Green (Blink)Red/Orange (Blink)GreenProgramming

The Status LED will turn off and on at 500 ms intervals when Blink is specified along with a single color. When

two colors are specified, the LED will alternate between the two colors every 500 ms instead of between off

and on states.

1.1.3 Micro-USB Receptacle

Plug a USB to Micro-USB cable into the Micro-USB Receptacle (see figure highlight C) and connect Apple

iBeacon into a USB power adapter to charge.

1.1.4 Slide Switch

The Slide Switch (see figure highlight D) has 3 possible positions:

●

Off

●

Momentary

Apple iBeacon will enter Programming mode when the Slide Switch is moved from the On position to the

Momentary position and held there for a minimum of 3 seconds. The Slide Switch may be released after Apple

iBeacon has entered this mode.

1.2 Accessories

The following accessories are not included with Apple iBeacon and must be purchased separately:

1.2.1 USB power adapter

Use any Apple USB power adapter to power Apple iBeacon and charge the battery. The Apple 5W USB Power

Adapter is recommended.

1.2.2 USB to Micro-USB cable

Use any standard USB to Micro-USB cable to connect Apple iBeacon to a USB power adapter to charge.

1. At a Glance

1.2 Accessories