Specifications
Table Of Contents
- Color StyleWriter 6500
- Basics
- Specifications
- Troubleshooting
- Take Apart
- Paper Tray
- Top Cover
- Access Door
- Side Access Door
- Keypad Bezel
- Lightpipe Assembly
- Base
- Logic Board EMI Shield
- Power Supply EMI Shield
- Logic Board
- Power Supply Board
- Flex Clamp
- Ribbon Cable
- Access Door Actuator
- Ground Plane
- Encoder Strip
- Encoder Stiffener
- Carriage Belt
- Turnaround Assembly
- Idler Assembly
- Carriage Motor
- Purge Unit
- Absorber Assembly
- Purge Unit Motor
- Paper Motor
- Mechanical Assembly
- Additional Procedures
- Exploded View
Troubleshooting Symptom Charts/LEDs - 26
Power and Resume
lights on steady,
printer won’t print
1 Try recycling power to printer.
2 Check that correct printer driver is selected.
3 Replace the printer cable, retest.
4 Check the clutch actuator. Make sure it’s free from
obstructions and moves freely. See “Fixing Carriage Stalls”
in Additional Procedures for clutch location.
5 Reseat logic board connectors. Replace logic board.
6 Replace mechanical assembly.
Power light on but
Resume light
flashing, printer
won’t print
1 Install media. Make sure media is not buckled in IN tray and
paper length and width adjusters are firmly against media
stack.
2 Check for paper jam. See Additional Procedures.
3 Install ink cartridge or replace empty ink cartridge. Make
sure ink cartridge snaps into place and cover is closed. Refer
to “Cleaning Paper Jams” in Additional Procedures.
4 Reseat ink cartridge.
5 Press Resume button. Page should print and eject to OUT tray.