Specifications
Table Of Contents
- Color StyleWriter 6500
- Basics
- Specifications
- Troubleshooting
- Take Apart
- Paper Tray
- Top Cover
- Access Door
- Side Access Door
- Keypad Bezel
- Lightpipe Assembly
- Base
- Logic Board EMI Shield
- Power Supply EMI Shield
- Logic Board
- Power Supply Board
- Flex Clamp
- Ribbon Cable
- Access Door Actuator
- Ground Plane
- Encoder Strip
- Encoder Stiffener
- Carriage Belt
- Turnaround Assembly
- Idler Assembly
- Carriage Motor
- Purge Unit
- Absorber Assembly
- Purge Unit Motor
- Paper Motor
- Mechanical Assembly
- Additional Procedures
- Exploded View
Troubleshooting Symptom Charts/LEDs - 25
Power and Resume
lights flashing
alternately, printer
won’t print
1 Make sure the top cover is closed.
2 Verify printer connections.
3 Verify proper printer driver and printer port are selected.
4 Perform printer self tests. Refer to “Printer Tests” in
Additional Procedures.
5 Replace printer cable.
6 Reseat logic board connectors. Replace logic board.
7 Verify that paper-out actuator contacts sensor on the logic
board. If not, replace actuator.
8 Replace mechanical assembly.
9 Look for oil or excessive ink on the encoder strip. Clean the
encoder strip with water. Replace if necessary.
10 Replace the carriage motor.
11 Refer to “Carriage Stall” in Additional Procedures.