Specifications
Table Of Contents
- Color StyleWriter 6500
- Basics
- Specifications
- Troubleshooting
- Take Apart
- Paper Tray
- Top Cover
- Access Door
- Side Access Door
- Keypad Bezel
- Lightpipe Assembly
- Base
- Logic Board EMI Shield
- Power Supply EMI Shield
- Logic Board
- Power Supply Board
- Flex Clamp
- Ribbon Cable
- Access Door Actuator
- Ground Plane
- Encoder Strip
- Encoder Stiffener
- Carriage Belt
- Turnaround Assembly
- Idler Assembly
- Carriage Motor
- Purge Unit
- Absorber Assembly
- Purge Unit Motor
- Paper Motor
- Mechanical Assembly
- Additional Procedures
- Exploded View
Troubleshooting Symptom Charts/Paper - 16
Paper
Paper sticks together 1 Fan paper and remove excess sheets from paper tray.
2 Verify that media meets specifications.
3 Stack media against right wall of In Tray.
4 Verify that paper-out actuator contacts sensor board. If not,
replace actuator.
5 If actuator does contact sensor board, replace board.
6 Remove pressure plate and check for obstructions.
7 Replace pressure plate.
8 Replace mechanical assembly.
Paper skews 1 Perform diagnostic test to verify that print skew is out of
specification. Refer to Additional Procedures.
2 Inspect paper tray. Make sure it’s firmly installed. Replace
and retest.
Note
: If margin on left side of page gets larger,
cause is likely the input tray.
3 Inspect width adjuster. Make sure width adjuster is against