Specifications
Table Of Contents
- Color StyleWriter 6500
- Basics
- Specifications
- Troubleshooting
- Take Apart
- Paper Tray
- Top Cover
- Access Door
- Side Access Door
- Keypad Bezel
- Lightpipe Assembly
- Base
- Logic Board EMI Shield
- Power Supply EMI Shield
- Logic Board
- Power Supply Board
- Flex Clamp
- Ribbon Cable
- Access Door Actuator
- Ground Plane
- Encoder Strip
- Encoder Stiffener
- Carriage Belt
- Turnaround Assembly
- Idler Assembly
- Carriage Motor
- Purge Unit
- Absorber Assembly
- Purge Unit Motor
- Paper Motor
- Mechanical Assembly
- Additional Procedures
- Exploded View
Additional Procedures X-Y Calibration - 47
X-Y Calibration
After replacing the logic board or mechanical assembly
you must use the Color SW 6500 X-Y Calibration utility
to set factory default carriage values in printer memory.
The Color SW 6500 X-Y Calibration utility is on the
Companion CD (path: Diagnostic Utilities/Color SW 6500
Utilities).
1 Copy the Color SW 6500 X-Y Calibration folder to
the computer, and make sure the printer is on and
connected to the computer’s printer port.