Specifications
Table Of Contents
- Color StyleWriter 6500
- Basics
- Specifications
- Troubleshooting
- Take Apart
- Paper Tray
- Top Cover
- Access Door
- Side Access Door
- Keypad Bezel
- Lightpipe Assembly
- Base
- Logic Board EMI Shield
- Power Supply EMI Shield
- Logic Board
- Power Supply Board
- Flex Clamp
- Ribbon Cable
- Access Door Actuator
- Ground Plane
- Encoder Strip
- Encoder Stiffener
- Carriage Belt
- Turnaround Assembly
- Idler Assembly
- Carriage Motor
- Purge Unit
- Absorber Assembly
- Purge Unit Motor
- Paper Motor
- Mechanical Assembly
- Additional Procedures
- Exploded View
Basics Special Servicing Considerations - 15
X-Y Calibration
After replacing the logic board or mechanical assembly on a
Color StyleWriter 6500, you
must
use the Color SW 6500
X-Y Calibration utility to set factory default carriage values
in printer memory. The Color SW 6500 X-Y Calibration
utility is on the Companion CD (path: Diagnostic Utilities/
Color SW 6500 Utilities).
Refer to Additional Procedures for more information.
Capping Unit
If a Color StyleWriter 6500 printer is brought in for
service, and the customer has had the printer for awhile,
replace the purge unit (922-2912) which contains the
capping assembly.