Specifications
Table Of Contents
- Color StyleWriter 6500
- Basics
- Specifications
- Troubleshooting
- Take Apart
- Paper Tray
- Top Cover
- Access Door
- Side Access Door
- Keypad Bezel
- Lightpipe Assembly
- Base
- Logic Board EMI Shield
- Power Supply EMI Shield
- Logic Board
- Power Supply Board
- Flex Clamp
- Ribbon Cable
- Access Door Actuator
- Ground Plane
- Encoder Strip
- Encoder Stiffener
- Carriage Belt
- Turnaround Assembly
- Idler Assembly
- Carriage Motor
- Purge Unit
- Absorber Assembly
- Purge Unit Motor
- Paper Motor
- Mechanical Assembly
- Additional Procedures
- Exploded View
Additional Procedures Default Settings - 43
Default Settings
After replacing the logic board you must use the Color SW
6500 Default Settings utility to download customer
default settings to the replacement logic board. The Color
SW 6500 Default Settings utility is on the Companion CD
(path: Diagnostic Utilities/Color SW 6500 Utilities).
Important: If the settings are not reset, the carriage will
not center when the access door is lifted, making it
impossible for the customer to insert/remove print
cartridges. Therefore, it is important for the printer to
be set from “manufacturing mode” to “customer mode”
after a logic board is replaced.
1 Copy the Color SW 6500 Default Settings folder to
the computer and make sure the printer is on and
connected to the computer’s printer port.