Manual

Attaching and Removing the Desktop Stand and Flip-Out Stand 45

Attaching the Flip-Out Stand

1 If necessary, remove the desktop stand. (See “Removing the Desktop Stand” on page 43.)

2 Hook the three plastic tabs on the top cover of the ﬂip-out stand into the three openings on

the back center area of the display.

3 Place the bottom part of the cover against the display and screw in the two plastic

thumbscrews.

Use a coin or ﬂathead screwdriver to tighten the screws. Don’t overtighten the screws; you

might strip the threads.

4 Flip out the stand and place the display with the stand on a ﬂat surface, such as a table or

desk.

5 For Mac OS–based computers, connect the ADB cable on your keyboard or other type of

input device into the ADB port (marked with V) on the back of the display.

6 Lift the display up slightly and press the power (®) button on the right underside of the

display to turn it on.

7 Turn your computer on.

8 If desired, attach a locking cable to the security slot on the back of the display.

For more information, see the documentation that came with the locking cable.

Note: To use any of the controls on the underside of the display, you need to lift the display

up slightly.

First, hook the

flip-out stand

on to the back

of the display.

Then tighten

the thumbscrews.