User guide

49
SETUP Adobe Photoshop 7+
Adobe Photoshop 7+
Since Photoshop 7.0 allows a plug-in to have access to multiple layers, the layered document may contain
additional inputs to AdvantEdge. Previous Photoshop versions required the additional inputs to be imported
from within the AdvantEdge interface.
The Photoshop 7 document must be created as follows:
1 The foreground must be the the top-most layer
2 The background should be immediately below the foreground.
3 The clean plate should be immediately below the background.
4 The holdout matte should be immediately below the clean plate.
After entering the AdvantEdge interface, the corresponding inputs must be enabled by clicking on or click
on More and then the Inputs tab. The Inputs palette will appear. Click the eye to the on position for each input.
If the document is “missing” an input that is between 2 existing inputs, then a layer must be used in the place
of the input. This layer may be fully transparent or a duplicate of any other layer that exists in the document.
Inputs Palette: the Background
and Clean Plate have been
turned on.