Operation Manual
Table Of Contents
- Contents
- 1 Getting Started With the QuickTake 100 Camera
- 2 Using the Camera to Take Pictures
- 3 Using the Camera With Your Macintosh
- 4 QuickTake Software Menu Commands
- 5 Maintenance and Troubleshooting
- Appendix A Specifications
- Appendix B Battery Information
- Appendix C Using the Camera with a Windows-Based PC
- Appendix D Using QuickTake Setup
- Index
Do you have what you need?
Before you begin, unpack the QuickTake 100 package. Be sure you have the
items shown in this illustration:
System requirements
To use the QuickTake 100 camera with your computer, you need
m a Macintosh with a 68020 or higher central processing unit (any Macintosh
except a Macintosh Plus, SE, Classic, Portable, or PowerBook 100)
m system software version 7.0.1• (with Tune-Up 1.1.1) or a later version
m 4 MB of RAM with 8 MB of virtual memory or 8MB of RAM
m an Apple SuperDrive (or any floppy drive that can read high-density disks)
m a hard drive with at least 10 MB available
QuickTake 100 camera
Battery charger
Rechargeable NiCad
batteries
Serial cable
QuickTake software
Neck strap
2
Chapter 1