Operation Manual
Table Of Contents
- Contents
- 1 Getting Started With the QuickTake 100 Camera
- 2 Using the Camera to Take Pictures
- 3 Using the Camera With Your Macintosh
- 4 QuickTake Software Menu Commands
- 5 Maintenance and Troubleshooting
- Appendix A Specifications
- Appendix B Battery Information
- Appendix C Using the Camera with a Windows-Based PC
- Appendix D Using QuickTake Setup
- Index
Erasing pictures from the camera
After you transfer your pictures to your Macintosh, you should erase them
from the camera to make room for new pictures.
If the camera is connected to your Macintosh, there’s another way to erase
pictures. You can open the QuickTake program and choose Camera Controls
from the Camera menu. Then click the Erase All button on the Macintosh
screen.
WARNING
This erases all of the pictures in the camera. You cannot
erase a few and leave the rest in the camera.
To erase all the pictures in the camera,
lightly
press the Erase All button.
(Use any small, pointed object.)
As the pictures are erased, the Trash icon in the
control panel display blinks. In a few seconds,
the display shows 0 (zero) pictures taken.
38
Chapter 3