Operation Manual
Table Of Contents
- Contents
- 1 Getting Started With the QuickTake 100 Camera
- 2 Using the Camera to Take Pictures
- 3 Using the Camera With Your Macintosh
- 4 QuickTake Software Menu Commands
- 5 Maintenance and Troubleshooting
- Appendix A Specifications
- Appendix B Battery Information
- Appendix C Using the Camera with a Windows-Based PC
- Appendix D Using QuickTake Setup
- Index
Using the controls
When the camera is on, the control panel display appears.
Flash settings
There are three possible settings for the flash. Each time you press the flash
button, you cycle from one setting to the next.
A
To let the camera’s light
sensor determine when
to flash, press the button
until you see this icon.
For a flash with
every picture,
press the button
until you see this icon.
To turn off the flash,
press the button until
you see this icon.
A
stands for
automatic.
When you turn on or
wake the camera, this
setting always appears.
When your subject is in
shadow, and the background
is brighter, use this setting.
A
Flash button
Erase All button
(explained in Chapter 3)
Control panel display Resolution button
Timer button
12
Chapter 2