Operation Manual
Table Of Contents
- Contents
- 1 Getting Started With the QuickTake 100 Camera
- 2 Using the Camera to Take Pictures
- 3 Using the Camera With Your Macintosh
- 4 QuickTake Software Menu Commands
- 5 Maintenance and Troubleshooting
- Appendix A Specifications
- Appendix B Battery Information
- Appendix C Using the Camera with a Windows-Based PC
- Appendix D Using QuickTake Setup
- Index
What if you upgrade your Macintosh system software?
If you decide to replace or upgrade your Macintosh system software after
you’ve installed the QuickTake software, you may not be able to open the
QuickTake application program. To fix this problem, reinstall the QuickTake
software.
As an alternative, you can use the custom Installer:
1 Insert the appropriate installation disk into a floppy disk drive.
The choice depends on whether you have a Power Macintosh or not.
m If you have a Power Macintosh, insert QuickTake for Power Macintosh.
m Otherwise, insert QuickTake Install Disk 1.
If necessary, open the disk icon.
2 Double-click the Installer icon to open it.
3 In the Welcome dialog box that appears, click OK.
4 In the Installer dialog box, click Customize.
5 Choose Shared Library Manager from the list.
6 Click Install.
7 When you see a message reporting that the installation was successful, click Restart.
You have reinstalled the Shared Library Manager, and you can open the
QuickTake program again.
What next?
To begin taking pictures, go on to Chapter 2.
8
Chapter 1
Use the Installer to install
the QuickTake software.