User Guide

PowerBook G4
Memory
Replacement Instructions
Be sure to follow the instructions in this sheet carefully. Failure to follow these instructions
could result in damage to your equipment and may void your warranty.
If you are adding memory rather than replacing it, skip the section “Removing Memory
Cards.
Note:
Written and video instructions covering customer-installable parts are available at
http://www.info.apple.com/installparts/.
Warning: Sharp edges can exist inside your computer and on any parts being
removed or installed. Use caution to avoid injury.
Tools Required
The only tool required for this procedure is a jeweler’s flat-blade screwdriver.
Memory (RAM)
Your computer comes with two memory slots, one above the other. From the factory, your
PowerBook comes with one memory card installed in the lower slot.
Note:
If desired, you can install additional memory in the upper memory slot or replace a
memory card in either slot with one of greater memory capacity, up to a maximum of a
512
megabyte
(MB) memory
card installed in each slot.
Warning: Memory cards come in various specifications. Only install memory cards
that are approved for your PowerBook.
Opening the Computer
1. Place your computer on a clean, flat surface.
2. Shut down your computer. Disconnect the power cord and any other cables connected
to the computer.
Warning: Always turn off your computer before opening its case to avoid
damaging its internal components.

Summary of content (8 pages)