Instruction Manual

Getting ready

You need the Duo Dock, a NuBus card, and either a flat-slot or Phillips

screwdriver (depending on the type of screws you see in step 5 under

“Installing the Card”).

If your system is already set up: Tur n off, disconnect, and remove all

equipment attached to the dock, but do not unplug the power cord that

connects the dock to an electrical outlet or power strip.

Installing the card

1Unlatch the top cover of the dock by pinching the grooved surface just inside the

front opening.

2When the latches release, tilt the cover upward slightly (to about a 30° angle) and then lift

the angled cover straight up to remove it.

This Not This

Chapter 3