Installation manual

The "Easy Install" option installs:
• AppleTalk 58.0.2
• The selected Asante EtherTalk software driver
Before an installation, check with your network administrator to verify that the
software and hardware is compatible with this AppleTalk version. If you do have a
compatibility problem, you MUST select the “Customize” option and install ONLY
Asante’s EtherTalk driver.
NOTE: DO NOT DRAG INSTALL APPLETALK FILES INTO THE SYSTEM FOLDER. YOU MUST
USE THE INSTALLER.
If you are installing an Asante Ethernet adapter, select and double-click the
"Installer" icon. This installs the required software for all Asante Ethernet adapters.
The adapter must first be installed before using the Installer. The Installer will
automatically select the correct driver for your Asante Ethernet adapter.
Easy Install for Asante EN/SC, Mini EN/SC and Micro EN/SC (SCSI-to-Ethernet). If you
are installing an Asante EN/SC, Mini EN/SC or Micro EN/SC to any Macintosh (see
NOTE below), the Installer checks your Macintosh to see if there is a network card
installed. If not, it will automatically select the correct files to install for the
EN/SC. If a network card is detected, you must select the Customize install option to
install the EN/SC driver software.
NOTE: The EN/SC and EN/SC PB is not compatible with the Macintosh IIfx or 68040
computers, including LC475, 575, Centris or Quadra series computers.
----------------------------------------------------
Custom Installation - Asante Ethernet Controllers
Use this option to install specific Asante Ethernet software.
1. Select and double-click the Installer icon.
2. Click on the "Customize" button.
3. A list of specific software that can be installed appears. Select one or
Shift-select to select more than one software item to install.
4. To select a drive other than the active startup drive, use “Switch Disk”.
5. Click the "Install".
6. Restart your Macintosh.
----------------------------------------------------
- 5 -