User guide

5. Loosen the two screws connecting the central part of

the dock to the base. (In the rest of these instructions,

the central part of the dock is called the subassembly.)

Check the screws to determine whether they are slot or

Philips screws and then select the appropriate screwdriver.

Tu rn the screws counterclockwise. The screws don’t come out

all the way, so you can’t remove them completely.

6. Pull the subassembly toward you until you feel it come

to a stop.

It will move only a short distance. You’ll be able to feel a small

gap under the front ledge of the dock.

If the subassembly doesn’t seem to move, or if you can’t feel a

gap under the front ledge, the screws may not be loose

enough. Turn them a few more times and try again.

The subassembly is heavy, so before you continue with step 7,

make sure that you have enough room to put it down nearby after

you lift it off the base.

continues .

Screws