User`s manual

Installing the Rhapsody packages
1 If you are not connected to a NetInfo (Rhapsody) network, enter Y to start up the
computer in non-network mode.
If your computer is connected to a NetInfo network, the computer
automatically starts up in network mode.
IMPORTANT After the computer starts up, the Install Rhapsody dialog box
appears. It may take a few moments for this dialog box to appear. Do not
restart or turn off your computer.
2 Select all the packages you want to install.
Note: It’s recommended that you install all the packages. With this version of
the Installer, you cannot reinstall additional packages later.
3 Click Install to begin the installation.
When the installation is finished, a message appears on the screen.
4 Click Restart.
Starting Rhapsody
When your computer restarts, you see a blue screen with a menu bar. After
a moment, the Rhapsody welcome screen appears. There may be a long
delay before the welcome screen first appears. Do not turn off or restart your
computer.
You’re asked to configure the language and keyboard options. (In this version,
English is the only available language.)
m Select a keyboard layout, then click OK.
After a moment, the installation process is complete and the Rhapsody
workspace appears.
WARNING Don’t click Quit or Stop while installing Rhapsody or you
may leave your hard disk in an unusable state and have to start the
installation from the beginning.
8
Chapter 2