User`s manual

Selecting the destination hard disk

1 Enter 1 to begin the installation.

2 Enter the number displayed next to the destination disk you want to use.

Initializing the hard disk

After you’ve selected a disk, you are asked if you want to use the whole disk

or partition for Rhapsody, or whether you want to set aside a portion of the

disk for Mac OS files.

Using the entire disk

Note: This is the recommended option.

1 Enter 1 to use the entire disk for Rhapsody.

2 If you want to be able to access this disk from the Mac OS, enter Y to create an HFS

(Mac OS) partition.

Creating this small Mac OS partition will allow the disk to be recognized by

the Finder if you start the computer using the Mac OS. Also, the Installer will

install some Rhapsody documentation onto this partition so you can access

the documentation while using the Mac OS.

After you confirm your selections, the hard disk is initialized. This process

takes a few minutes.

Using a pre-existing partition

If you created an HFS partition of at least 600 MB, as described in

Chapter 1, choose this option. If you partitioned the hard disk using LaCie

SilverLining, be sure you have read the partitioning information in Chapter 1

before you continue.

WARNING

All files and information on the selected disk will be erased

during the installation process.

Chapter 2