User`s manual

Configure your Mac OS monitor settings

With this version of Rhapsody, you use the Mac OS Monitors & Sound

control panel to set your monitor to the resolution and color depth you want

to use when you’re using Rhapsody.

If you have an AppleVision monitor, make sure the monitor’s ADB cable is

connected to the ADB port on the back of the computer. If you don’t do this,

the monitor may have a black screen when you start up with Rhapsody. (See

Chapter 4, “Troubleshooting,” if this occurs.) See your AppleVision user’s

manual for information about connecting the ADB cable.

Arrange your SCSI devices

With this version of Rhapsody, adding or removing SCSI devices after

installation can cause Rhapsody’s device numbering system to change. If this

happens, you will be asked to specify a device number when you start the

computer.

To avoid this, it is strongly recommended that you do the following:

m Remove any “extra” devices that you don’t need to use with this computer.

m Make sure that the disk where you’re installing Rhapsody is the lowest-

numbered device in your external SCSI chain.

Chapter 1