Instruction manual

Chapter 1: Installing the Splash Interface Hardware Page 23
Connecting the Printer/Copier
Make sure your printer/copier has a Port Kit installed on it by Xerox service.
The Port Kit is necessary for connecting the Splash Server to the printer/copier.
1. Push the 68-pin connector on the interface cable into the port on the Splash
interface card. (See the following figure for the port location.)
2. Push the 100-pin end of the interface cable into the port on the back of the
printer/copier and hand tighten the two screws to secure the cable.
Splash Key
The Splash Key is a hardware device that connects to the ADB port on your
computer. The Splash Key prevents unauthorized use of the Splash Server software
and also provides maximum security by locking the Splash Server application when
the key is removed.
To install the Splash Key,
1. Shut down the Splash Server Macintosh (if it is powered on).
2. Disconnect the ADB keyboard cable from the connector on the back of your
Macintosh. (The ADB keyboard cable connects to the keyboard ADB port and
the ADB port on your computer.)
3. Connect the large end of the Splash Key to the ADB keyboard cable.
Interface card
port, with 68-pin
connector
Printer/copier port
with 100-pin connector