Instruction manual

Page 22 Splash PCI Series v5.0 Install Manual
Do not force the Splash board into place. If the board does not seat properly in
the PCI slot, remove it completely from the computer, then try again.
6. Close the expansion card cover. (Be sure that the cover snaps shut on
both ends.)
7. Replace the cover on the computer. Lower the cover onto the computer,
leaving a two-inch gap between the back panel of the computer and the back
edge of the cover. Push the cover toward the back of the computer until it snaps
into place.
8. Connect the power cable, display, keyboard, and other peripheral equipment to
the Splash Server computer.
The Splash PCI board install procedure is complete.