Instruction manual

Chapter 1: Installing the Splash Interface Hardware Page 21
3. Touch the metal power supply case inside the computer to discharge any static
electricity that may be present on your body.
4. Open the expansion card cover in the computer.
5. Install the Splash board into the PCI expansion slot in the computer.
Locate an empty PCI slot on the floor of the computer chassis. Align the
connector on the Splash PCI board to the access port. Align the other end of the
Splash board with the plastic guide provided for the expansion slot.
Align the gold fingered PCI connector on the board with the PCI slot, then
firmly but carefully press down on the top edge of the Splash board until
the PCI connector firmly seats in the expansion slot. The connector on the
Splash board should be visible through the access port.
Power supply case
Expansion card cover
Access port
PCI slot
Interface card guides
Expansion card cover