User`s guide

Installing the external video connector
assembly
1 Insert the small card into the monitor-out slot on the logic
board. The card will fit in the slot only one way.
2 Insert the video connector at the end of the ribbon cable
through the opening in the metal bracket. (The video
connector is sometimes called the monitor-out port.)
3 If there is slack in the cable, fold it as shown.
If you already have an expansion card installed in the
computer’s processor-direct slot, lay the cable over (not
under) the expansion card.
Monitor-out slot
Connectors
3 Insert the video connector
through the hole in the
metal bracket.
1 Insert the small card into the monitor-out slot. The card will fit
in the slot only one way.
2 Fold the ribbon cable as shown.
Metal bracket
Processor-direct slot
31
Installing in a Macintosh LC 580