Specifications

22 - Power Mac G5 Take Apart
AGP/PCI Card
33 MHz PCI slots and cannot use PCI-X cards; computers with eight DIMM slots can
accommodate 100 and 133 MHz PCI-X cards. See the chart below.
Card type PCI slot Card speed
PCI* slots 2, 3, and 4 64-bit, 33 MHz
PCI-X slots 2 and 3 64-bit, 100 MHz
slot 4 64-bit, 133 MHz
*The PCI slots can accommodate mixed-voltage (5.0 V, 12 V, or 3.3 V) cards but only at
3.3 V signaling, with 32-bit or 64-bit data widths and a 33 MHz frequency. You can add a
66 MHz card to a 33 MHz PCI slot if the card can operate at the lower 33 MHz rate.
Warning: Do not use PCI cards that function only at 66 MHz in the PCI slots. Damage to
the equipment could result. If you are installing an additional 66 MHz PCI card, rather than
replacing an existing PCI card like-for-like, check with the card’s manufacturer to see if the
new 66 MHz card also works at 33 MHz.
Tools
The only tool required for this procedure is a Phillips screwdriver.
Preliminary Steps
Before you begin, open the computer and lay it on its side with the access side facing up.
Part Location