Specifications

2 - Power Mac G4 (Mirror/FW 800) Take Apart
General Information
Important: The Take Apart procedures are the same for all versions of the computers
unless model differences are noted.
Tools
The following tools are required:
• #2 Phillips screwdriver
• #1 Phillips screwdriver
• T-10 Torx driver or 2.5 mm Allen wrench
• Small flat-blade screwdriver
• Needlenose pliers
Note: Magnetized tools are recommended to avoid dropping screws within the computer.
Note: To organize the screws you remove from the computer, use a tray with divided
compartments (such as a plastic ice cube tray).
Serial Number Location
The computer’s serial number is located on the back panel.
Before Opening the Computer
Warning: The power supply in this computer is a high-voltage component and should not
be opened for any reason, even when the computer is off.
Warning: After shutting down the computer, you must wait a few minutes before servicing
it to allow internal components to cool.
Important: The only way to shut off power completely to the computer and display is to
disconnect their power plugs from the power source. Make sure the power cords to the
computer and display are within easy reach.
Electrostatic Discharge (ESD) Precautions
Follow these steps to avoid damage from ESD before working inside the computer.
1. Shut down the computer.
2. Wait a few minutes to allow the computer’s internal components to cool.
3. Unplug all cables from the computer except the power cord.
4. Touch the metal PCI access covers on the back panel to discharge static electricity.
5. Unplug the power cord.
6. Lift the latch on the side of the computer. (If the latch will not lift, check that the
security lock port and lockable cover latch in the back of the computer are not locked.)