User Guide

PowerBook G4 Logic Board - 2
Procedure
1. From the keyboard opening, disconnect the three-pin fan connector.
2. Remove the Torx T8 screw that is closest to the PC card carrier.
3. Disconnect the PC Card ribbon cable connector and the six-pin keyed battery
connector.
Important: If the battery connector has not been disconnected before, the keyed
connector may be tight. If necessary, use a black stick to loosen one side of the
connector and then the other side. Then insert the black stick under the wires to pry
up and disconnect the connector.
Note: When reassembling the computer, tuck down the battery and fan cables so
they do not get in the way when the keyboard is installed.
®
Fan Connector
®
PC Card
Connector
Battery
Connector
Screw