Specifications

Using the Menu System
1-84 ❖ System Administrator Guide
Default Gateway
Set the four byte Default Gateway
address. The available values are:
xxx.xxx.xxx.xxx
Where xxx = 000 to 255
.
This item only appears if IP Address
Res. is set to
Static
.
For this item (after Step 3),
Item
Up
moves the cursor to the right
through the displayed Default
Gateway address and
Item Down
moves the cursor to the left. This
allows you to change characters
within the string rather than having to
re-enter the entire string.
With the cursor displayed under a
character,
Value Up
increments
the value of that character and
Value
Down
decrements the value.
1. Press
Menu Up
or
Menu
Down
until you see:
Menus
Token Ring Menu
2. Press
Item Up
or
Item
Down
until you see:
Token Ring Menu
Default Gateway
3. Press
Value Up
or
Value
Down
. You will see:
Default Gateway=
xxx.xxx.xxx.xxx
4. Press
Value Up
or
Value
Down
to change the value
of the character above the
cursor. The value is
incremented or decremented
by 1 each time the key is
pressed. Holding down
Value
Up
or
Value Down
causes continuous scrolling
through the values.
Default Gateway=
xxx.xxx.xxx.xxx
5. To change other characters in
the Default Gateway address,
press
Item Up
or
Item
Down
to scroll right or left
respectively through the
character string, then press
Value Up
or
Value
Down
to change the value
of the character above the
cursor (as in Step 4).
Default Gateway=
xxx.xxx.xxx.xxx
6. When you have completed
setting the Default Gateway
address, press
Enter
. You
will see:
Token Ring Menu
Default Gateway
7. Press
On Line
. You will see:
Ready
Table 1.24 Token Ring Menu functions
(continued)
Menu Item and Function Keystrokes Display
Table 1.24 Page 11 of 14