Specifications

Control Panel Messages
Chapter 5: Troubleshooting ❖ 5-27
Stapl Fail H5-92
Power Off/On
The Staple Head did not switch ON within the specified time. Power OFF and
ON the printer.
Stapl Fail H5-93
Power Off/On
The Stapler Failed in the Front Corner position. Power OFF and ON the
printer.
Stapl Fail H5-94
Power Off/On
The Stapler Failed in the Front Straight position. Power OFF and ON the
printer.
Stapl Fail H5-95
Power Off/On
The Stapler Failed in the Rear Straight position. Power OFF and ON the
printer.
Stapl Fail H5-96
Power Off/On
The Stapler Ready Sensor did not go back ON after the staples were refilled,
or stapling was unsuccessful. Power OFF and ON the printer.
Stapl Fail H5-97
Power Off/On
The End Wall Sensor of the Finisher did not go on ON or OFF within the
specified time. Power OFF and ON the printer.
Toner Low
Toner is getting low in the Laser Print Cartridge, but printing will continue
without interruption until the cartridge is empty. Replace the cartridge as
soon as possible.
Tray 1 Empty
This tray is no longer being used to print because it is empty. Refill the tray if
it is to be used again.
Tray 2 Empty
This tray is no longer being used to print because it is empty. Refill the tray if
it is to be used again.
Tray 3 Empty
This tray is no longer being used to print because it is empty. Refill the tray if
it is to be used again.
Table 5.2 Control Panel messages and corrective actions
(continued)
Message Description/Corrective Action
Table 5.2 Page 23 of 24