Specifications

Using the Menu System
Chapter 1: Configuring the Printer ❖ 1-105
Disk Format
Format the Hard Disk Drive. The
available values are:
Yes
No*
Normally, this function is used only if
the disk has not been formatted
previously. Initiating this command on
a formatted disk will write over any
existing data on the disk.
This function is ignored if the disk is
locked (write protected) via a PJL or
SNMP command.
1. Press
Menu Up
or
Menu
Down
until you see:
Menus
Reset Menu
2. Press
Item Up
or
Item
Down
until you see:
Reset Menu
Disk Format
3. Press
Value Up
or
Value
Down
until you see:
Disk Format =
Yes
4. Press
Enter
. During
formatting, you will see:
Disk Format
Please Wait...
5. When the formatting is
complete, you will see:
Ready
Flash Format
Format flash memory. The available
values are:
Yes
No*
1. Press
Menu Up
or
Menu
Down
until you see:
Menus
Reset Menu
2. Press
Item Up
or
Item
Down
until you see:
Reset Menu
Flash Format
3. Press
Value Up
or
Value
Down
until you see:
Flash Format =
Yes
4. Press
Enter
. During
formatting, you will see:
Flash Format
Please Wait...
5. When the formatting is
complete, you will see:
Ready
Table 1.30 Reset Menu functions
(continued)
Menu Item and Function Keystrokes Display
Table1.30 Page4 of 4