Installation manual

Installation
To add the MultiRam //e card to the RGB card, hold the RGB card in one hand
and hold the MultiRam //e card in the other hand. Hold the RGB card so that
the memory card connector pins on the back of the RGB card (just above the
gold fingered connectors on the bottom of the card) face the RGB connector
socket on the front of the MultiRam //e card (just above the gold fingered
connectors). The slanted part of each card should be facing in the same
direction.
Align the two connectors. The top pins of the RGB connector should fit into
the top holes of the MultiRam //e socket and the bottom pins into the bottom
holes. Make sure that the pins of the RGB card are not off one or more holes
along the length of the female connector.
WARNING: Be careful! If the cards are incorrectly connected, you may
damage the RAM on the MultiRam cards or other MultiRam
components. Double check the connection for good alignment
before inserting the two cards back into the Apple //e.
Push the two cards together until a firm connection is made.
To remove the MultiRam //e card to add more memory to it or for any other
reason, after turning off the //e, first remove the combined cards from the
auxiliary slot.
Next, with both hands use a back-and-forth rocking motion along the width of
the cards. Continue rocking until the two cards separate from one another.
Instructions for attaching the MultiRam Plus card to the MultiRam RGB are
the same as for the MultiRam //e card.
MultiRam EX Card
The 65C816 on the EX card can directly address all memory on the MultiRam
RGB card when the EX card is connected to the RGB card by a cable.
Assembly instructions are in the MultiRam EX manual.
INSTALLING THE MULTIRAM RGB CARD
The MultiRam RGB Card must first be configured for the type of lie it is to
be used in.
page 18