User Manual

Choosing a good location for your monitor

Here are some key factors to consider when determining where to place your

monitor:

m Be sure that the desk or table can support the monitor’s weight—

approximately 30 pounds.

m Make sure that the power cord will reach an available AC outlet.

m Make sure the monitor cable will reach from the back of the monitor to

your computer. The monitor cable should be unobstructed when you swivel

and tilt the monitor, so allow at least 6 inches of clearance in the back. If

you don’t allow enough clearance, the monitor connector might be

damaged when the cable hits an obstruction.

Installing the monitor base

After choosing a good location for the monitor, install the monitor base:

1Place the monitor on its side so that the bottom, where the base will be attached,

is exposed.

2 Insert the base’s hooked tabs into the slots on the bottom of the monitor.

The small arrow inside the base should point toward the front of the monitor,

and the small raised tab on the edge of the base should point toward the back.

Release latch

Setting Up