5

Any parameter controlled by a rig is added to the Widget Inspector, below the Edit Mode:
Start button and above the Options parameters.
After you click the Stop Rig Edit Mode button, no additional parameters are added to the
widget.
To cancel the recording of the snapshot, click the close button on the Stop Rig Edit Mode
window. When you stop recording, changes made to parameters are saved, but no new
parameters are added to the widget.
Note: Each parameter can be controlled by only one widget. After a parameter is assigned
to a widget, you cannot assign that parameter to additional widgets.
You can add parameters to a widget after a snapshot is created by clicking the Start Rig
Edit Mode button again and making changes to new parameters, or by manually adding
parameters to the widget. See Controlling Rigs from Parameter Animation Menus.
Important: After a parameter is added to a widget, changes made to that parameter
change the selected snapshot even if Rig Edit Mode is stopped, and even if the Widget
Inspector is not visible.
To record a snapshot on the fly
1 Add a rig to the project by pressing Command-Control-R.
The rig appears in the Layers list.
2 In the Rig Inspector, click the Add Pop-up button (or whichever widget type you prefer).
490 Chapter 10 Using Rigs