5

• Source value between min and max: When this item is selected, the link applies only
when the source value stays within a defined range. If the source value falls below the
defined minimum, or exceeds the defined maximum, the link behavior stops. When
selected, the Clamp Source Values Within Range checkbox as well as offset, minimum,
and maximum sliders for each setting associated with the source parameter appear at
the bottom of the Behaviors Inspector. If the source parameter has a single slider, such
as shape Feather, one set of three sliders (offset, minimum, and maximum) appears for
that setting. If the source parameter has multiple sliders, such as Fill Color (red, green,
blue), sets of three sliders appear for each of those settings.
• Source value outside min and max: When this item is selected, the link applies only when
the source value stays outside of a defined range. If the source value falls above the
defined minimum, or below the defined maximum, the link behavior stops. When
selected, the Clamp Source Values Within Range checkbox as well as offset, minimum,
and maximum sliders for each setting associated with the source parameter appears
at the bottom of the Behaviors Inspector. If the source parameter has a single slider,
such as Outline Width, one set of three sliders (offset, minimum, and maximum) appears
for that setting. If the source parameter has multiple sliders, such as Shear X-Y, sets of
three sliders appear for each of those settings.
Clamp Source Value Within Range: This checkbox becomes available when the Apply
Link pop-up menu is set to a choice requiring a minimum or maximum value. When
selected, values that exceed the defined range are pinned to the highest or lowest
allowable setting.
(Parameter) offset: This slider allows you to create a constant offset between the source
parameter value and the value applied to the target parameter.
(Parameter) min: When the Apply Link When pop-up menu is set to “Source value above
minimum,” “Source value between min and max,” or “Source value outside min and max,”
a “min” slider appears for each component of the source parameter. Adjusting this slider
defines a minimum value to limit when the link behavior is active.
(Parameter) max: When the Apply Link When pop-up menu is set to “Source value below
maximum,” “Source value between min and max,” or “Source value outside min and max,”
a “max” slider appears for each component of the source parameter. Adjusting this slider
defines a maximum value to limit when the link behavior is active.
HUD Controls
The HUD lets you set all parameters and change the parameter source and target.
431Chapter 9 Using Behaviors