5.5

577Motion User Guide
The Sequence Replicator controls appear in the Behaviors Inspector. For the behavior to
have any effect on the replicator, you must add parameters using the Parameter pop-up
menu at the top of the Sequence Replicator controls. For details, see the next task.
Add and animate parameters in the Behaviors Inspector
After you apply the Sequence Replicator behavior to a replicator, you must assign one
or more parameters for the behavior to modify. In the following example, the Rotation,
Opacity, and Scale parameters are assigned to the Sequence Replicator behavior in the
Behaviors Inspector.
1. In the Layers list or Timeline in Motion, select the Sequence Replicator behavior.
2. In the Parameter row of the Behaviors Inspector, do the following:
a. Click the Add pop-up menu, then choose Rotation.
b. Click the Add pop-up menu, then choose Opacity.
c. Click the Add pop-up menu, then choose Scale.
The added parameters appear above the Add and Remove pop-up menus. No
animation occurs until you set a value for the parameters.
3. Ensure that keyframe recording is turned off (make sure the Record button in the timing
toolbar is not highlighted solid red).
4. In the Behaviors Inspector, drag the Rotation dial to set a spin value.
In this example, Rotation is set to 160 degrees, so that each element rotates from 0 degrees
to 160 degrees over the pattern for the duration of the Sequence Replicator behavior.