3

Chapter 2 Delay eects 59
Create taps with the Tap pad
1 Click the upper pad (Start).
Note: Whenever you click the Start pad, it automatically erases all existing taps. Because of this
behavior, after you create your initial taps, you will want to create subsequent taps by clicking in
the Identication bar.
The upper pad label changes to Tap, and a red tap recording bar appears in the strip below the
view buttons.
2 To begin recording new taps, click the Tap button.
3 To create new taps, click the Tap button.
These are created at the exact moments in time of each click, adopting the rhythm of your
click pattern.
4 To nish creating taps, click the Last Tap button.
The nal tap is added, ending tap recording, and assigning the last tap as the feedback tap (for
more information about the feedback tap, see Delay Designer master parameters on page 69).
Note: If you do not click the Last Tap button, tap recording automatically stops after 10 seconds
or when the 26th tap is created, whichever comes rst.
Create a tap in the Identication bar
m Click the position where you want to add a tap.
Copy taps in the Identication bar
m Option-drag a selection of one or more taps to the position where you want to add the tap
or taps.
The delay time of copied taps is set to the drag position.