3

Chapter 13 Space Designer convolution reverb 236
Use Space Designer EQ parameters
Space Designer has a four-band EQ consisting of two parametric mid-bands plus two shelving
lters (one low shelving lter and one high shelving lter). You can edit the EQ parameters
numerically in the parameter bar or graphically in the main display.
EQ On/Off button Individual EQ band buttons
•
EQ On/O button: Click to turn the entire EQ section on or o.
•
EQ band buttons: Click to turn individual EQ bands on or o.
•
Frequency elds: Set the frequency for the selected EQ band.
•
Gain elds: Cut or boost the selected EQ band.
•
Q elds: Set the Q factor for the two parametric bands. The Q factor can be adjusted from 0.1
(very narrow) to 10 (very wide).
Graphically edit an EQ curve in Space Designer
1 Enable the EQ and one or more bands with the EQ On/O and EQ band buttons in the top row
of the parameter bar.
2 Move the cursor horizontally over the main display. When the cursor is in the access area of a
band, the corresponding curve and parameter area are automatically highlighted and a pivot
point is displayed.
3 Drag horizontally to adjust the frequency of the band.