User Guide

Mac Pro Take Apart — Mac Pro RAID Card and Battery 62
Mac Pro RAID Card & Battery
Note: If a Mac Pro RAID Card is installed in a Mac Pro, the standard iPass cable routing has been
changed so that the cable connects to the card, rather than to the logic board.
Tools
The only tool required for this procedure is a Phillips #1 screwdriver. You might also nd a small
at-blade screwdriver helpful in releasaing the iPass cable connector.
Preliminary Steps
Before you begin, open the computer, lay it on its side with the access side facing up, and remove
the following:
All h• ard drives and hard drive carriers
PCI Express card installed in slot 1 and a• ny 12-inch PCI Express cards
Top and bottom memory cards•
Processor heatsink cove• r
Front fan assembl• y
Part Location