User Guide
Table Of Contents
- Mac Pro (8x)
- Contents
- Basics
- Take Apart
- General Information
- Opening the Computer
- Hard Drives
- Optical Drive Carrier and Optical Drives
- Memory (FB-DIMMs) and Memory Riser Cards
- PCI Express/Graphics Card
- Power Supply
- Power Supply Fan
- AirPort Extreme Card
- Bluetooth Card
- Battery
- Processor Heatsink Cover
- Front Fan Assembly
- Mac Pro RAID Card and Battery
- Memory Cage with Rear Fan
- Processor Heatsinks
- Processors
- Speaker Assembly
- USB Cable
- Logic Board
- Front Panel Board
- Power Button
- AirPort Antenna Board with Cables
- Optical Drive Power Cable
- Optical Drive Data (Ribbon) Cable
- Ambient Board
- Ambient Board Cable
- Bluetooth Antenna Board and Cable
- Hard Drive Cable Harness
- Hard Drive Temperature Sensor Cable
- Hard Drive Temperature Sensor
- Power Cable Harness
- Troubleshooting
- Upgrades
- Views
Mac Pro (8x) Take Apart — AirPort Extreme Card 45
Remove the card from the enclosure.4.
Replacement Note: To replace the AirPort Extreme card, do the following:
Connect the antenna wires to the card. •
Important: Be sure to connect the wires that are marked 1 and 3 to the card; the antenna
wire that is marked 2 should be taped out of the way.
Insert the card into its logic board connector at an angle, as illustrated. •
Lower the screw end of the card down to the standos on the logic board and replace the •
two mounting screws.
Note: If you are not replacing the AirPort card, cover the connectors on the AirPort antenna wires
with Kapton or other non-conductive tape to prevent them from shorting out components on
the logic board.