User Guide
Table Of Contents
- Mac Pro (8x)
- Contents
- Basics
- Take Apart
- General Information
- Opening the Computer
- Hard Drives
- Optical Drive Carrier and Optical Drives
- Memory (FB-DIMMs) and Memory Riser Cards
- PCI Express/Graphics Card
- Power Supply
- Power Supply Fan
- AirPort Extreme Card
- Bluetooth Card
- Battery
- Processor Heatsink Cover
- Front Fan Assembly
- Mac Pro RAID Card and Battery
- Memory Cage with Rear Fan
- Processor Heatsinks
- Processors
- Speaker Assembly
- USB Cable
- Logic Board
- Front Panel Board
- Power Button
- AirPort Antenna Board with Cables
- Optical Drive Power Cable
- Optical Drive Data (Ribbon) Cable
- Ambient Board
- Ambient Board Cable
- Bluetooth Antenna Board and Cable
- Hard Drive Cable Harness
- Hard Drive Temperature Sensor Cable
- Hard Drive Temperature Sensor
- Power Cable Harness
- Troubleshooting
- Upgrades
- Views
Mac Pro (8x) Take Apart — Bluetooth Antenna Board and Cable 11 7
Bluetooth Antenna Board and
Cable
The Bluetooth antenna cable is part of the Bluetooth antenna board assembly. To remove or
replace the cable, you must replace the antenna board assembly.
Tools
The only tool required for this procedure is a jeweler’s at-blade screwdriver.
Preliminary Steps
Before you begin, open the computer, lay it on its side with the access side facing up, and remove
the following:
All hard drives and hard drive carrier• s
All PCI Express card• s
Processor heatsink cove• r
Front fan assembl• y
Top and bottom memory cards with DIMM• s
Memory cag• e with rear fan
Processor heatsink• s
Speaker assembl• y
USB cabl• e
AirPort Extreme card (if installed• )
Bluetooth card (if installed• )
Logic boar• d