User Guide
Table Of Contents
- Mac Pro (8x)
- Contents
- Basics
- Take Apart
- General Information
- Opening the Computer
- Hard Drives
- Optical Drive Carrier and Optical Drives
- Memory (FB-DIMMs) and Memory Riser Cards
- PCI Express/Graphics Card
- Power Supply
- Power Supply Fan
- AirPort Extreme Card
- Bluetooth Card
- Battery
- Processor Heatsink Cover
- Front Fan Assembly
- Mac Pro RAID Card and Battery
- Memory Cage with Rear Fan
- Processor Heatsinks
- Processors
- Speaker Assembly
- USB Cable
- Logic Board
- Front Panel Board
- Power Button
- AirPort Antenna Board with Cables
- Optical Drive Power Cable
- Optical Drive Data (Ribbon) Cable
- Ambient Board
- Ambient Board Cable
- Bluetooth Antenna Board and Cable
- Hard Drive Cable Harness
- Hard Drive Temperature Sensor Cable
- Hard Drive Temperature Sensor
- Power Cable Harness
- Troubleshooting
- Upgrades
- Views
Mac Pro (8x) Take Apart — Ambient Board Cable 116
Procedure
Remove any tape holding the ambient board cable to the enclosure.1.
Disconnect the ambient board cable from the ambient board and logic board. 2.
Using a magnetized #1 Phillips screwdriver, remove the two mounting screws on the hard 3.
drive connector for drive bay 1 and move the connector out of the way.
Route the ambient board cable out through the opening in the media shelf and remove the 4.
cable from the enclosure.
Important: After you replace the ambient board cable, you must reset the System Management
Controller. Refer to “Resetting the Logic Board” in the Troubleshooting chapter.