User Guide
Table Of Contents
- Mac Pro (8x)
- Contents
- Basics
- Take Apart
- General Information
- Opening the Computer
- Hard Drives
- Optical Drive Carrier and Optical Drives
- Memory (FB-DIMMs) and Memory Riser Cards
- PCI Express/Graphics Card
- Power Supply
- Power Supply Fan
- AirPort Extreme Card
- Bluetooth Card
- Battery
- Processor Heatsink Cover
- Front Fan Assembly
- Mac Pro RAID Card and Battery
- Memory Cage with Rear Fan
- Processor Heatsinks
- Processors
- Speaker Assembly
- USB Cable
- Logic Board
- Front Panel Board
- Power Button
- AirPort Antenna Board with Cables
- Optical Drive Power Cable
- Optical Drive Data (Ribbon) Cable
- Ambient Board
- Ambient Board Cable
- Bluetooth Antenna Board and Cable
- Hard Drive Cable Harness
- Hard Drive Temperature Sensor Cable
- Hard Drive Temperature Sensor
- Power Cable Harness
- Troubleshooting
- Upgrades
- Views

Mac Pro (8x) Basics 11
Krytox Thermal Grease
To ensure a proper seal between the heatsink and processor, a bead of Krytox grease rims •
the gasket on the underside of the heatsink. Replacement heatsinks come with the grease
already applied.
Use the following guidelines for when to reapply Krytox grease to the heatsink. (Refer to •
“Processor Heatsinks” in the Take Apart chapter for detailed instructions on how to apply or
clean o the grease.)
In most cases, you do not need to reapply Krytox grease when installing a new -
processor or when transferring processors and heatsinks to a replacement logic board.
If you are installing a new heatsink , remove any residual grease from the outer edges -
of the processor. Do not apply new grease to the heatsink or processor, as the heatsink
comes with the full capacity of grease applied.
For more detailed information, refer to “Processor Heatsinks” and “Processors” in the Take Apart
chapter.
Safety and First Aid Guidelines
Below is a summary of safety and rst aid measures for exposure to the coating on the processor
heatsink and processor or the Krytox grease used in sealing the processor heatsink to the
processor. For complete instructions, refer to the specic Material Safety Data Sheets (MSDS)
included with the replacement parts.
Safety
Avoid contact with eyes.
Avoid contact with skin.
Wash thoroughly after handling.
Do not store or consume food, drink, or tobacco in areas where they may become
contaminated with the material.
First Aid
Eyes: Immediately ush with plenty of water. If wearing contact lenses, after initial ushing,
remove contact lenses and continue to ush for 15 minutes. Have eyes examined by a
medical professional if irritation persists.
Skin: Wash skin with soap and running water. The recommended ushing is 15 minutes if
pain or irritation occurs. Remove and wash contaminated clothing. Seek medical attention if
irritation or redness develops.
Inhalation: Remove to fresh air. If not breathing, give articial respiration. If breathing is
dicult, give oxygen. Call a physician.
Ingestion: Do not induce vomiting. Contaminated individual should immediately be given
two glasses of water. Never give anything by mouth to someone who is unconscious, having
convulsions, or unable to swallow. Call a physician.










