Specifications

Working Inside Your Server 43

To install an additional Ultra ATA drive in the front carrier:

Release the ribbon cable from the cable clamp.

2 Remove the power and ribbon cables from any installed drive.

3 Slide the drive carrier away from the chassis.

4 Install the ATA drive in the drive carrier and screw it into position.

Note: Contact your drive manufacturer or consult the manufacturer’s website to determine

if your drive is set for cable select mode. Before installation, set the drive to cable select if the

manufacturer hasn’t already done so.

If necessary, remove

the ribbon and power

cables from any hard

disk drives already

installed in the carrier.

Then press down on the

tab located on the side

of the carrier, and slide

the drive carrier out.