Installation guide

14
Installing the MPEG Card
Installing the card in Style A
1 Turn off the computer.
m Choose Shut Down from the Special menu, or press the
Power key on the keyboard.
m Press the power switch at the back of the computer.
Press the side of the switch marked with the j symbol.
2 Unplug all cables except the power cord from the computer.
Leaving the power cord plugged in helps protect the
computer from electrostatic discharge damage.
Important To avoid generating static electricity that may
damage components, do not walk around the room until
you have finished installing the card and closed the
computer. In addition, move the logic board as little as
possible while it is outside the computer.
3 Use a Phillips screwdriver to remove the two security screws
from the back panel.
Remove both security screws.