Installation guide

7 Swing the handle out from its storage position, then grasp
the handle and gently but firmly pull it toward you.
The vertical plate and the logic board to which it’s attached
slide all the way out of the computer.
8 Remove the MPEG card from its static-proof bag.
Hold the card by its edges to avoid touching any connectors.
9 Set the MPEG card down, component side up, and attach
either end of the ribbon cable to the shorter of the two
connectors on the card, as shown.
continues .
With the components on the card facing up, install
the ribbon cable as shown (you can use either end).
Pull out the
logic board.Wire handle
7
Installing the MPEG Card