Installation guide

5
Installing the MPEG Card
To install the MPEG card in a computer with a separate
monitor, follow these steps:
1 Turn off the computer.
You can do this by choosing Shut Down from the Special
menu.
2 Unplug all the cables except the power cord from your
computer.
Leaving the power cord plugged in until you’re ready to
remove the logic board from the computer helps protect the
computer from electrostatic discharge damage.
Important To avoid generating static electricity that may
damage components, do not walk around the room until
you have finished installing the card and closed the
computer. In addition, move the logic board as little as
possible while it is outside the computer.
3 Place your thumbs on the two tabs at the top of the plastic
panel, and press down.
continues .