User`s guide

4Press down on the card until the connector is solidly in place.
Don’t force the card. If you meet resistance, pull the card out and try again.
To s ee if the card is properly connected, lift it gently. If it resists and stays in
place, it’s connected.
Closing the computer
1Slip the base of the logic board into the guide rails inside the computer’s case and swing
the wire handle back into its storage position.
Make sure the logic board slides
into the guides that are on both
sides of the computer’s interior.
Swing the handle up, into its storage position.
93
Installing an Expansion Card